This Loaded Stratocaster SSS pickguard features Alnico 5, hand-wound with hotter on the bridge and clean on the neck pickups wound and assembled entirely by me. It’s a drop-in replacement for most modern Strats. Just solder the output jack and you’re ready to play. I hand-wind every coil myself in small batches, chasing that clean, airy, bell-like Strat tone I’ve always loved. I gig with the same pickups I sell and I’m constantly tinkering with Strats. This is not a kit full of cheap parts, it’s a lovingly built piece of gear made in short runs, one at a time. You’ll hear the difference: classic Strat chime, great definition, and touch-sensitive response. Wiring follows vintage Fender spec. The neck is right about vintage 50s spec giving you a bright bell like Strat tone and the bridge is slightly warmer to balance the volume. The middle is a balance between the two. It’s a relatively bright winding of the pickups with scooped mids and nice high end. If you want a different colour or spec, check my other listings or send me a message. I often have variations available. Elektrisola 42 AWG wire. Alnico 5 rod magnets. RWRP middle for hum-cancelling in 2 & 4. CTS dish back pots. Genuine Fender 5-way Grigsby switch. Pickguard still has protective film.