SHG5014 Hot Modern Noiseless Loaded Stratocaster 3-Ply Black Pickguard USA Spec

Posted On July 18, 2026 | Comments Closed |

Fender USA Spec Electronics & Wiring. Parchment Light Cream Knobs & Covers. Sale Includes The Items Listed Below In New Condition. SHG5014 Modern Hot Noiseless Pickups (Full Output Readings Above). Modern Wiring (Bridge/Middle Tone Control 1) (Neck Tone Control 2). Sprague/CDE Orange Drop Capacitor. Artist Series Treble Bleed (102K 1KV). 11 Hole 3-Ply Black Pickguard Fender. USA & MIM Spacing. Genuine CTS 250K Potentiometers (Vintage Dish-Back). Vintage Gavitt Cloth Wire. This setup lands right in the middle between the high-powered shredders and the vintage classic Fender output without the 60-cycle hum and feedback. Strong enough to cut through any mix without losing the classic chime when needed and suitable for all genres of music. The soldering job is meticulously done to the highest standard. Plenty of wire to connect and drop in!

Posted under shg5014 Tags: 3-ply, black, loaded, modern, noiseless, pickguard, shg5014, spec, stratocaster

2004 Fender Stratocaster MIM Loaded 3-Ply Pickguard SSS Cream with HW

Posted On July 3, 2026 | Comments Closed |

For your consideration is this 2004 Fender Stratocaster Standard MIM Loaded 3-Ply Cream SSS pickguard with factory mounting hardware. This pickguard is in great pre-owned condition with no cracks or chips. There is some light pick wear consistent with doing its job. As you can see, the pickups measure between 7.69k, 7.60k and 7.66k. Pots range between 278.7k and 245.4k. Feel free to ask any questions. Thank you for looking.

Posted under fender Tags: 3-ply, cream, fender, loaded, pickguard, stratocaster

Fender Eric Johnson Stratocaster Loaded Pickguard Parchment 3-ply

Posted On June 16, 2026 | Comments Closed |

3-ply white Fender pickguard loaded with Fender Eric Johnson pickups and electronics. Great sounding unit will be an easy installation. On your stratocaster project. Lower 48 USA only.

Posted under fender Tags: 3-ply, eric, fender, johnson, loaded, parchment, pickguard, stratocaster

2001 Fender Stratocaster MIM Loaded 3-Ply Pickguard SSS Cream with HW

Posted On May 2, 2026 | Comments Closed |

For your consideration is this 2000 Fender Stratocaster MIM Loaded 3-Ply aged white or cream SSS pickguard with factory mounting hardware. This pickguard is in good pre-owned condition with no cracks or chips. A previous owner added a Roland Synth module to the guitar so there are a pair of small holes on either side of the bridge. Pickguard has aged from what was likely a parchment color to more of an aged white or cream color now. There is some pick wear in keeping with doing its job. Otherwise, it’s very clean with average pick wear. As you can see, the pickups measure between 6.75k and 6.52k. Pots range between 237.9k and 242.3k. Feel free to ask any questions. Thank you for looking.

Posted under fender Tags: 3-ply, cream, fender, loaded, pickguard, stratocaster

Fender Hot Noiseless SSS Loaded Stratocaster 3-Ply Tortoiseshell Pickguard

Posted On March 11, 2026 | Comments Closed |

Fender Pre-wired Pickguard with Custom’69 Pickups. Hot noiseless pickups Polysol-coated magnet wire Ceramic magnets deliver scorching output Flush-mount pole pieces for even string response Vinyl-coated output wire and plastic bobbin Product Description Customize your tone with the pre-wired Stratocaster pickguards. Made with premium components in the same factory as our iconic guitars, This drop-in pickguard is easy to install. Simply remove your old guard, solder the output jack and ground wires, screw in the new guard and you’re ready to rock with pure Fender sound. Made with premium components in the same factory as our iconic guitars, this drop-in pickguard is easy to install.

Posted under fender Tags: 3-ply, fender, loaded, noiseless, pickguard, stratocaster, tortoiseshell

1996 Fender Stratocaster MIM Loaded 3-Ply Pickguard SSS Cream with HW

Posted On February 15, 2026 | Comments Closed |

Fender Stratocaster Pickups & Loaded Pickguard – Made in Mexico. Original Fender Stratocaster pickups and pickguard assembly, removed from a 1996 Made in Mexico Stratocaster. This is a classic SSS configuration, mounted to a white pickguard with Fender knobs and switch. Pickups are original Fender MIM single coils and are ideal for a traditional Strat build or restoration project. Wiring leads are intact as shown. Fender Stratocaster pickups (3 single coils). Made in Mexico. Original Fender knobs and switch. Removed from a 1996 MIM Strat.

Posted under fender Tags: 3-ply, cream, fender, loaded, pickguard, stratocaster

Fender Squier Standard LOADED PICKGUARD Tortoise Shell 3-Ply SSS Stratocaster

Posted On February 2, 2026 | Comments Closed |

This listing is for a Loaded Pickguard. It is in good working condition. At the time I tested it, neither the pots nor switch were scratching. It came from a Fender Squier Standard Series Stratocaster that I parted out. It comes with a set of 11 screws. Make sure to check the pictures and ask any questions before purchasing.

Posted under fender Tags: 3-ply, fender, loaded, pickguard, shell, squier, standard, stratocaster, tortoise

2015 Fender Stratocaster Standard MIM Loaded 3-Ply Pickguard SSS White with HW

Posted On January 10, 2026 | Comments Closed |

For your consideration is this 2015 Fender Stratocaster Standard MIM Loaded 3-Ply White SSS Pickguard with factory mounting hardware. This pickguard is in great pre-owned condition with no cracks or chips. There is some light oxidation on some of the mounting screws and pole pieces. Otherwise, it’s very clean with average pick wear. As you can see, the pickups measure 6.72k at the bridge to 6.75k middle and 6.77k in the neck. Pots range between 268.1k and 246.8k. Feel free to ask any questions. Thank you for looking.

Posted under fender Tags: 3-ply, fender, loaded, pickguard, standard, stratocaster, white

2004 Fender Stratocaster Standard MIM Loaded 3-Ply Pickguard HSS Cream with HW

Posted On June 29, 2025 | Comments Closed |

For your consideration is this 2004 Fender Stratocaster Standard MIM Loaded 3-Ply Cream SSS Pickguard with factory mounting hardware. This pickguard is in great pre-owned condition with no cracks or chips. There is some light oxidation on some of the mounting screws and pole pieces. Otherwise, it’s very clean with average pick wear. As you can see, the pickups measure 6.91k at the bridge to 7.04k middle and 7.23k in the neck. Pots range between 238.4k and 214.4k. Feel free to ask any questions. Thank you for looking.

Posted under fender Tags: 3-ply, cream, fender, loaded, pickguard, standard, stratocaster

1987 Squier Stratocaster Japan E-Series Loaded Pickguard White 3-Ply

Posted On June 22, 2025 | Comments Closed |

For your consideration is this 1987 Squier Stratocaster Japan E-Series Loaded Pickguard. This white, 3-ply, pickguard is in great pre-owned condition and works just as it should. All electronics function correctly. As you can see, pickups measure 5.74k (B), 5.79k (M), and 5.70k (N). Pots read between 284.4k and 310.8k. Feel free to ask any questions. Thank you for looking.

Posted under squier Tags: 3-ply, e-series, japan, loaded, pickguard, squier, stratocaster, white

1 2 3 Next »

July 2026
M	T	W	T	F	S	S
« Jun
		1	2	3	4	5
6	7	8	9	10	11	12
13	14	15	16	17	18	19
20	21	22	23	24	25	26
27	28	29	30	31