Choose your own colour combination. I’ll confirm your selection before I begin assembling your pickguard to make sure everything is exactly as you want it. Hand-wound’60s Strat-style loaded pickguard, prewired with quality components and ready to drop straight into your guitar. Designed, wound and assembled in my workshop on the Barrington Coast, NSW. Each product is hand made. The result is a classic’60s Strat tone with added sparkle on the top end, while still holding onto body and balance. Fitted with a treble bleed circuit to keep your tone clear and responsive as you roll the volume back without losing top end. I’ve also wired the second tone control to operate both the middle and bridge pickups. Everything is fully assembled, hand-wired and tested before it leaves the bench, so you get a clear, articulate setup that drops straight into your guitar. No soldering, no chasing parts, no guesswork. High scatter, hand-wound Classic’60s Strat-style single coils. Remington poly magnet wire. Middle: 6.0k? (RWRP for hum-cancelling in positions 2 & 4). Oak Grigsby 5-way blade switch. CTS 250k audio taper pots. 0.047µF Elpac 225P film capacitor. Tone 2: Middle + Bridge. Built and assembled by Remi Perkins on the Barrington Coast, NSW. Every setup is wound, assembled and tested in small batches using the same components I use in my own guitars. Looking for something a little different?