Neck humbucker: 7.5K (3.75K split-coil). Bridge humbucker: 15K (7.5K split-coil). Weight: 700g per set. Tip: Please check the pickguard size chart carefully before purchasing to make sure the hole pattern is compatible with your pickups, otherwise you may need to make necessary adjustments. 1 x 3-ply guitar pickguard. 3 Alnico 5 humbucker pickups. 1 Enhanced Toggle Switch. 3 potentiometers (1 volume, 2 tone, copper shaft). 4 single-cut toggle switches. 1 x 400V/200V capacitor. In addition to the original functions, two single-cut toggle switches bring new functions. For example, toggle on + 5-position switch in bridge position = neck and bridge pickups work simultaneously.
MATERIAL: Alnico 5 pickups and imported copper wire. 3 x 500K potentiometers (1 volume, 2 tone). 4 single pole switches. 1 x output jack. 5-way switch for different styles of tones. Suitable for upgrading any common guitar setup. Accessories: 11 screws included for easy installation. In addition to the original functions, four single-knife switches and an enhancement switch bring new functions. The boost switch is pressed: the neck and bridge pickups operate simultaneously. In the second position, the neck and center pickups work together. Boost switch pressed: neck, center, and bridge pickups operate simultaneously. If the single cutter does not produce a good sound, use the compensation switch.
Loaded Prewired SSH Pickguard Set. Material:Alnico 5 Pickups+ White copper base plate. DCR: N 6.16K M 6.57K B 17.5K 1 × 5 way switch. 1 × on/off Toggle. 2T 1V Potentiometer(CTS Brass Potentiometer). 7 way switch, can get 10 Different Style Sounds, perfect replacement for upgrading any common guitars configuration. Suitable for most Fender ST guitars. Simple, solder the reserved wire to the guitar spring claw. Toggle on + 5-way at the bridge pickups = neck and bridge pickups work together. Toggle on + 5-way at the middle pickups = neck and middle pickups work together.
Genuine Fender Stratocaster Noiseless Loaded Pickguard. This is an 11 hole pickguard with plastic still on, 5 way switch Black bottom neck 10, middle 10, bridge 10.
Built to capture the blues sound. These pickups are attack sensitive and respond to very light pick attack, as well as having a lot of snap with a heavy attack. Can be mellow or bright depending on the style of play. I believe these are similar to the pickups that SRV had in his Lenny guitar as they are very clean yet powerful. Controls are master volume, master tone and blender pot, which blends the neck & bridge pickups. I find the blender pot to be quite useful as you can make the bridge a little less bright or use it like a Telecaster configuration.
The product is covered with a protective film to prevent scratches and damage prior to installation on the guitar. This protective film needs to be removed before installation. Material: Alnico 5 pickups and imported copper wire. Note: Resistance values are for reference only; actual values will vary with temperature. Potentiometers: 3 (2 CTS 500K potentiometers and 1 split-axis push-button switch potentiometer) 1V 2T. Capacitor: 1 orange capacitor. Output Jack: 1 pc. 5-WAY SWITCH: You can get different styles of tones, perfect for upgrading any common guitar setup. In addition to the basic functions, four single-cut switches and an enhancement switch provide additional functionality. When the boost switch is pressed, the neck and bridge pickups will operate simultaneously. When the 5-way switch is placed in the second position, the neck and center pickups operate together. When the Enhance switch is pressed, the neck, center and bridge pickups will operate simultaneously. If the sound after a single cut is not satisfactory, it is recommended that a compensation switch be used.